HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch command line - Page 27
Configuring the Ethernet port, Verifying a switch in the network, You can use
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
The show setup system command displays the switch network configuration, as shown in the following example: 8/20q FC Switch #> show setup system System Information EthNetworkEnable True EthNetworkDiscovery Static EthNetworkAddress 10.20.11.32 EthNetworkMask 255.255.252.0 EthGatewayAddress 10.20.8.254 AdminTimeout 30 InactivityTimeout 0 LocalLogEnabled True RemoteLogEnabled False RemoteLogHostAddress 10.0.0.254 NTPClientEnabled True NTPServerAddress 51.68.85.102 EmbeddedGUIEnabled True Configuring the Ethernet port Configure the switch Ethernet port using the set setup system command in an Admin session. The following example configures a new IP address, subnet mask, and gateway address. 8/20q FC Switch (admin) #> set setup system A list of attributes with formatting and current values will follow. Enter a new value or simply press the ENTER key to accept the current value. If you wish to terminate this process before reaching the end of the list press 'q' or 'Q' and the ENTER key to do so. EthNetworkDiscovery EthNetworkAddress EthNetworkMask EthGatewayAddress 10.20.30.254 AdminTimeout InactivityTimeout LocalLogEnabled RemoteLogEnabled RemoteLogHostAddress NTPClientEnabled NTPServerAddress EmbeddedGUIEnabled (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) [Static ] (dot-notated IP Address) [10.0.0.1 ]10.20.30.40 (dot-notated IP Address) [255.255.255.0] 255.0.0.0 (dot-notated IP Address) [10.0.0.254 ] (dec value 0-1440 minutes, 0=never) [30 ] (dec value 0-1440 minutes, 0=never) [0 ] (True / False) [True ] (True / False) [False ] (dot-notated IP Address) [10.0.0.254 ] (True / False) [False ] (dot-notated IP Address) [10.0.0.254 ] (True / False) [True ] Do you want to save and activate this system setup? (y/n): [n] y Verifying a switch in the network You can use the ping command to verify that a switch is communicating in the network. The following example successfully tests the network for a switch with IP address 10.20.11.57. 8/20q FC Switch #> ping 10.20.11.57 Ping command issued. Waiting for response... 8/20q FC Switch #> Response successfully received from 10.20.11.57. If the switch was unreachable, you would see the following display: 8/20q FC Switch #> ping 10.20.11.57 Ping command issued. Waiting for response... No response from 10.20.11.57. Unreachable. 8/20q Fibre Channel Switch command line interface guide 27