HP StorageWorks SN6000 HP StorageWorks 8/20q Fibre Channel Switch command line - Page 100
Configuring a RADIUS server on the switch, Table 48
![]() |
View all HP StorageWorks SN6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Configuring a RADIUS server on the switch To configure a RADIUS server on the switch, enter the set setup radius command. There are two groups of RADIUS configuration parameters. One group of parameters is common to all RADIUS server configurations. The second group is server-specific. You can configure both groups of parameters for all RADIUS servers, or you can configure the common and server-specific parameters separately. See Table 48 and Table 49 for descriptions of the common and server-specific RADIUS configuration parameters. The following example configures the common RADIUS server configuration parameters: 8/20q FC Switch (admin) #> set setup radius common A list of attributes with formatting and current values will follow. Enter a new value or simply press the ENTER key to accept the current value. If you wish to terminate this process before reaching the end of the attributes for the server being processed, press 'q' or 'Q' and the ENTER key to do so. If you wish to terminate the configuration process completely, press 'qq' or 'QQ' and the ENTER key to so do. PLEASE NOTE SSL must be enabled in order to configure RADIUS User Authentication SSL can be enabled using the 'set setup services' command. Current Values: DeviceAuthOrder UserAuthOrder TotalServers Local Local 1 New Value (press ENTER to not specify value, 'q' to quit): DeviceAuthOrder 1=Local, 2=Radius, 3=RadiusLocal : UserAuthOrder 1=Local, 2=Radius, 3=RadiusLocal : TotalServers decimal value, 0-5 : Do you want to save and activate this radius setup? (y/n): [n] 100 RADIUS server configuration
![](/manual_guide/products/hewlettpackard-ak241a-hp-storageworks-820q-fibre-channel-switch-command-line-interface-guide-56977517-2008-397a799/100.png)