HP StorageWorks SN6000 HP StorageWorks 8/20q Fibre Channel Switch command line - Page 158
hotreset, disconnecting, and HBA configuration changes.
![]() |
View all HP StorageWorks SN6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
hotreset Description Resets the switch for the purpose of activating the pending firmware without disrupting traffic. This command terminates all management sessions, saves all configuration information, and clears the event log. After the pending firmware is activated, the configuration is recovered. This process may take a few minutes. To save the event log to a file before resetting, enter the set log archive command. Authority Admin session Syntax hotreset Notes You can load and activate firmware upgrades on an operating switch without disrupting data traffic or having to re-initialize attached devices. If the non-disruptive activation fails, you will usually be prompted to try again later. Otherwise, the switch will perform a disruptive activation. Verify that the current firmware version supports the installation and non-disruptive activation of the new firmware version. For information about compatible firmware versions, see the Firmware Release Notes. To ensure a successful non-disruptive activation, you should first satisfy the following conditions: • No changes are being made to switches in the fabric including installing firmware, powering up, powering down, disconnecting or connecting ISLs, and changing the switch configuration. • No port on the switch is in the diagnostic state. • No zoning changes are being made on the switch. • No changes are being made to attached devices, including powering up, powering down, disconnecting, connecting, and HBA configuration changes. • No more than two Simple SAN Connection Manager sessions are open. Ports that change states during the non-disruptive activation will be reset. When the non-disruptive activation is complete, Simple SAN Connection Manager sessions and QuickTools sessions are automatically reconnected. However, Telnet sessions must be restarted manually. This command clears the event log and all counters. TIP: After upgrading firmware that includes changes to QuickTools, a QuickTools session that was open during the upgrade may indicate that the new firmware is not supported. To correct this, close the QuickTools session and the browser window, then open a new QuickTools session. See also hardreset, page 155 reset, page 181 set log, page 206 158 Command reference
![](/manual_guide/products/hewlettpackard-ak241a-hp-storageworks-820q-fibre-channel-switch-command-line-interface-guide-56977517-2008-397a799/158.png)