HP StorageWorks SN6000 HP StorageWorks 8/20q Fibre Channel Switch command line - Page 182
set log, hardreset, hotreset, Table 25, IPv4 Ethernet
![]() |
View all HP StorageWorks SN6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
switch Resets the switch without a power-on self test (POST). This is the default. This reset disrupts traffic and does the following: • Activates the pending firmware • Closes all management sessions • Clears the event log. To save the event log before resetting, see the "set log" on page 206. To reset the switch with a power-on self test, see the "hardreset" on page 155. To reset the switch without disrupting traffic, see the "hotreset" on page 158. NOTE: The following files are deleted from the switch during a switch reset: • Firmware image files that have not been unpacked • Configuration backup files • Support files system Resets the following system configuration settings to the factory default values: • DNS host (Table 25) • IPv4 Ethernet (Table 26) • IPv6 Ethernet (Table 27) • Event logging (Table 28) • NTP (Table 29) • Timers (Table 30) NOTE: Because this operand changes network parameters, the workstation could lose communication with the switch. This operand does not affect installed license keys. zoning Clears the zoning database and deactivates the active zone set. The zoning configuration parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain unchanged. See Table 21 for information about the zoning configuration parameters. 182 Command reference
![](/manual_guide/products/hewlettpackard-ak241a-hp-storageworks-820q-fibre-channel-switch-command-line-interface-guide-56977517-2008-397a799/182.png)