HP XP20000/XP24000 HP StorageWorks XP Disk Array Configuration Guide (T5278-96 - Page 91
Installing and configuring the host, Loading the operating system and software, WWN
![]() |
View all HP XP20000/XP24000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Installing and configuring the host This section explains how to install and configure Fibre Channel adapters (FCAs) that connect the host to the disk array. Loading the operating system and software Follow the manufacturer's instructions to load the operating system and software onto the host. Load all OS patches and configuration utilities supported by HP and the FCA manufacturer. Installing and configuring the FCAs Install and configure the FCA driver software and setup utilities according to the manufacturer's instructions. Configuration settings specific to the XP array differ depending on the manufacturer. Specific configuration information is detailed in the following sections. WWN The FCA configuration process might require you to enter the WWN for the array port(s) to which the FCA connects. Your HP representative can provide you this information or you can display this information on the SAN switch. Setting the disk and device parameters The queue depth parameter (max_throttle) for the devices must be set according to one of the options specified in Table 20 (page 92). Installing and configuring the host 91
![](/manual_guide/products/hewlettpackard-xp20000xp24000-hp-storageworks-xp-disk-array-configuration-guide-t527896047-2011-474aa25/91.png)