HP Xw460c HP ProLiant xw460c Workstation Blade: Maintenance and Service Guide - Page 43

Ensure that the dip switches at the rear of the PCIe riser board are in the ON position pushed

Get HP Xw460c - ProLiant - Blade Workstation PDF manuals and user guides View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

HP Confidential When replacing the graphics board, be sure to align the connectors on the graphics board (1) with the lower slot on the PCIe riser board (2), and then press the board into the slot until fully seated. Pull out on the sides of the PCIe retainer clip and place it onto the PCIe card cage so that the two inner clips enter the holes in the card cage, and then slide the PCIe retainer clip forward until it snaps into place. NOTE: Ensure that the dip switches at the rear of the PCIe riser board are in the ON position (pushed down toward the gold connectors). Removal and replacement procedures 43

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
HP Confidential
Removal and replacement procedures
43
When replacing the graphics board, be sure to align the connectors on the graphics board (1) with the
lower slot on the PCIe riser board (2), and then press the board into the slot until fully seated.
Pull out on the sides of the PCIe retainer clip and place it onto the PCIe card cage so that the two inner
clips enter the holes in the card cage, and then slide the PCIe retainer clip forward until it snaps into
place.
NOTE:
Ensure that the dip switches at the rear of the PCIe riser board are in the ON position (pushed
down toward the gold connectors).