HP Xw460c HP ProLiant xw460c Workstation Blade: Maintenance and Service Guide - Page 48
Tighten the two spring-loaded captive Torx-15 screws that secure the mezzanine connector board
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
HP Confidential 5. Loosen the two spring-loaded captive Torx-15 screws that secure the mezzanine connector board to the workstation blade system board. 6. Pull up on both ends of the mezzanine connector board to disconnect it from the system board. To replace the mezzanine connector board: 1. Align the mezzanine connector board with the connector on the workstation blade system board, and then press down on the mezzanine connector board to seat the connector. 2. Tighten the two spring-loaded captive Torx-15 screws that secure the mezzanine connector board to the system board. 3. Insert the anchoring pins on the expansion blade enclosure into the J-slots at the rear of the workstation blade and then lower the expansion blade onto the workstation blade, and then slide the expansion blade forward into place. Removal and replacement procedures 48