HP Z840 Maintenance and Service Guide - Page 68
Requires 2nd, processor, order, Card description, 0Mech, 3PCIe, Slot 5PCIe2, x8 PCIe3 x8, 2nd CPU]
View all HP Z840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Requires 2nd processor Load order Card description Type Slot 0(Mech only) Slot 1(PCI e3 x8) Slot 2(PCI e3 x16) Slot 3(PCIe 3 x8) Slot 4(PCIe 3 x16) Slot 5(PCIe2 x8) (PCIe3 x8 [2nd CPU]) Slot 6 Slot 7 (PCIe3 (PCIe x16) 2 x1) 10 Z Turbo Drive 2nd PCIe-x4 card (M.2) 2nd 1st 11 PCIe 1394b card PCIe-x1 Only6 12 PCIe Network (LAN) PCIe-x1; x4;x8 1st 4th 5th 2nd 3rd 13 eSATA bulkhead kit N/A 1st 2nd 14 MiniSAS-4x Cable N/A (PCI Bulkhead) Only MiniSAS- 4x Cable N/A See 15 (Chassis Panel note Opening) 4 * Slots 3 and 4 require second processor. 1: If two Tesla cards are installed, place the first Tesla card in Slot #6 and the second Tesla card in Slot #2 so both are on CPU0. Place the first graphics card in Slot #4. 2: If a second graphics card is used with a Tesla card, place the Tesla card in Slot #6 and the second graphics in the alternate slot(s). 3: If an LSI RAID card is being used with a Tesla card or second graphics card, place the Tesla/graphics card in Slot #6 and the RAID card in Slot 1. 4: Install this panel cable kit in the back panel opening found above slot 7. 5: If 2nd CPU configuration with Thunderbolt card, move E3 jumper to rear pins. 6: 1394 card is not supported in Slot 7 if double wide card loaded in Slot 6. NOTE: Slot sequenced from the rear I/O aperture to the board edge. 58 Chapter 3 Component replacement information and guidelines