HP Z840 Maintenance and Service Guide - Page 70
HP Z440 Workstations — Intel AHCI SATA controller guidelines
View all HP Z840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
HP Z440 Workstations - Intel AHCI SATA controller guidelines See HP Z440 Workstation system board components on page 5 to determine the location of system board connectors. NOTE: Port 0 is the default port for the boot drive (the default port can be changed manually in the BIOS). RAID card (RC) or system board (SB) connector Drive installation scenarios 1 2 RC J8 SAS HDD 1 SAS HDD 1-B RC J7 SAS HDD 2 SATA HDD 2-D RC J6 SAS HDD 3 SATA HDD 3-D RC J5 SAS HDD 4 SATA HDD 4-D SB SATA 0 - - SB SATA 1 - - SB SATA 2 ODD 1 ODD 1 SB SATA 3 ODD 2 ODD 2 SB SATA 4 eSATA (top) eSATA (top) SB SATA 5 eSATA (bottom) eSATA (bottom) eSATA = external SATA (2 ports per cable assembly) HDD = hard drive ODD = optical drive NOTE: Only the most common configurations are shown here. 3 SATA HDD 1-B SAS HDD 2-D SAS HDD 3-D SAS HDD 4-D - - ODD 1 ODD 2 eSATA (top) eSATA (bottom) 60 Chapter 3 Component replacement information and guidelines