HP ep9012 HP ep9010 Series Instant Cinema Digital Projector - User's Guide - Page 53

Replacing the battery in the remote control

Get HP ep9012 - Instant Cinema Digital Projector PDF manuals and user guides View all HP ep9012 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

Maintaining the projector 5. Insert the new lamp module into the projector and tighten the two screws. 6. Insert the tab on the front cover into the slot in the projector and close the cover. 7. Tighten the screws that hold the cover. 8. Turn on the projector. If the lamp does not turn on after the warm-up period, try reinstalling the lamp. 9. Press menu, go to Setup > Reset lamp hours, and press ok. Replacing the battery in the remote control 1. On the back of the remote control, push in the tab 1 and remove the battery cover 2 to reveal the batteries. 2. Remove the old batteries and install two new AAA batteries 3. 3. Install the battery cover. When discarding old batteries, contact your local waste-disposal provider regarding local restrictions on the disposal or recycling of batteries. User's Guide 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
Maintaining the projector
User’s Guide
53
5.
Insert the new lamp module into the projector and tighten the two screws.
6.
Insert the tab on the front cover into the slot in the projector and close the
cover.
7.
Tighten the screws that hold the cover.
8.
Turn on the projector. If the lamp does not turn on after the warm-up period,
try reinstalling the lamp.
9. Press
menu,
go to
Setup > Reset lamp hours,
and press
ok.
Replacing the battery in the remote
control
1.
On the back of the remote control, push in the tab
1
and remove the battery
cover
2
to reveal the batteries.
2.
Remove the old batteries and install two new AAA batteries
3
.
3.
Install the battery cover.
When discarding old batteries, contact your local waste-disposal provider
regarding local restrictions on the disposal or recycling of batteries.