HP xw3400 HP xw3400 Workstation - Hardware Reference Guide - Page 16

Removing the front bezel, damage to the internal components of the workstation.

Get HP xw3400 - Workstation PDF manuals and user guides View all HP xw3400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Removing the front bezel 1. Remove/disengage any security devices that prohibit opening the workstation. 2. Remove all removable media, such as diskettes or compact discs, from the workstation. 3. Turn off the workstation properly through the operating system, then turn off any external devices. 4. Disconnect the power cord from the power outlet and disconnect any external devices. CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the workstation. 5. Remove the workstation access panel. 6. Press the green latch on the bottom right of the chassis (1) to release the bottom of the bezel, then swing the bottom of the bezel away from the chassis (2) to release the top of the bezel. Figure 2-3 Removing the front bezel 10 Chapter 2 Hardware upgrades ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Removing the front bezel
1
.
Remove/disengage any security devices that prohibit opening the workstation.
2
.
Remove all removable media, such as diskettes or compact discs, from the workstation.
3
.
Turn off the workstation properly through the operating system, then turn off any external devices.
4
.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
Regardless of the power-on state, voltage is always present on the system board as
long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid
damage to the internal components of the workstation.
5
.
Remove the workstation access panel.
6
.
Press the green latch on the bottom right of the chassis (1) to release the bottom of the bezel, then
swing the bottom of the bezel away from the chassis (2) to release the top of the bezel.
Figure
2
-
3
Removing the front bezel
10
Chapter
2
Hardware upgrades
ENWW