HP xw3400 HP xw3400 Workstation - Hardware Reference Guide - Page 33
CAUTION, If installing a new drive
View all HP xw3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
3. Connect the power and data cables to the drive as indicated in the following illustrations. a. If you are installing an optical drive, connect the power cable (1) and data cable (2) to the back of the drive. Figure 2-22 Connecting the optical drive cables CAUTION: Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A sharp bend can break the internal wires. b. If you are installing a diskette drive, connect the data cable (1) and power cable (2) to the back of the drive. Figure 2-23 Connecting the diskette drive cables 4. If installing a new drive, connect the opposite end of the data cable to the appropriate system board connector. NOTE: If you are installing a SATA optical drive, connect the first optical drive to the white SATA connector on the system board labeled SATA1. Connect a second optical drive to the orange SATA connector labeled SATA3. If you are installing a diskette drive, connect it to the connector on the system board labeled FLOPPY P10. ENWW Installing additional drives 27