HP xw3400 HP xw3400 Workstation - Hardware Reference Guide - Page 42

Type 1, Removing and replacing a Coin Cell Battery Type 2

Get HP xw3400 - Workstation PDF manuals and user guides View all HP xw3400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

NOTE: On some workstation models, it may be necessary to remove an internal component to gain access to the battery. 7. Depending on the type of battery holder on the system board, complete the following instructions to replace the battery. Type 1 a. Lift the battery out of its holder. Figure B-1 Removing a Coin Cell Battery (Type 1) b. Slide the replacement battery into position, positive side up. The battery holder automatically secures the battery in the proper position. Type 2 a. To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out (1). b. To insert the new battery, slide one edge of the replacement battery under the holder's lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery (2). Figure B-2 Removing and replacing a Coin Cell Battery (Type 2) Type 3 a. Pull back on the clip (1) that is holding the battery in place, and remove the battery (2). 36 Appendix B Battery replacement ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
NOTE:
On some workstation models, it may be necessary to remove an internal component to
gain access to the battery.
7
.
Depending on the type of battery holder on the system board, complete the following instructions to
replace the battery.
Type 1
a
.
Lift the battery out of its holder.
Figure
B
-
1
Removing a Coin Cell Battery (Type 1)
b
.
Slide the replacement battery into position, positive side up. The battery holder automatically
secures the battery in the proper position.
Type 2
a
.
To release the battery from its holder, squeeze the metal clamp that extends above one edge
of the battery. When the battery pops up, lift it out (1).
b
.
To insert the new battery, slide one edge of the replacement battery under the holder’s lip with
the positive side up. Push the other edge down until the clamp snaps over the other edge of the
battery (2).
Figure
B
-
2
Removing and replacing a Coin Cell Battery (Type 2)
Type 3
a
.
Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
36
Appendix
B
Battery replacement
ENWW