IBM 8488 Hardware Maintenance Manual - Page 120
CRU/FRU
UPC - 000435695277
View all IBM 8488 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Note: See Chapter 7, "Parts listing Type 8488 and 8648," on page 129 to determine which components are replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU). CD-ROM drive Symptom FRU/action CD-ROM drive tray is not working. (The server must be powered on.) 1. Insert the end of a paper clip into the manual tray-release opening. 2. Run CD-ROM diagnostics. 3. CD-ROM drive. Note: See Chapter 7, "Parts listing Type 8488 and 8648," on page 129 to determine which components are replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU). Diskette drive Symptom FRU/action The diskette drive activity LED 1. If there is a diskette in the drive, verify that: stays lit, or the server bypasses the diskette drive, or the v The diskette drive is enabled in the Configuration/Setup utility program. diskette drive does not work. v The diskette is good and not damaged. (Try another diskette if you have one.) v The diskette is inserted correctly in the drive. v The diskette contains the necessary files to start the server. v The software program is working properly. v The cable is installed correctly (in the proper orientation). 2. To prevent diskette drive read/write errors, make sure that the distance between monitors and diskette drives is at least 76 mm (3 in.). 3. Run diskette drive diagnostics. 4. Cable. 5. Diskette drive. 6. System board. Note: See Chapter 7, "Parts listing Type 8488 and 8648," on page 129 to determine which components are replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU). General Symptom FRU/action Problems such as broken cover v Broken CRU/FRU locks or indicator LEDs not working Note: See Chapter 7, "Parts listing Type 8488 and 8648," on page 129 to determine which components are replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU). Hard disk drive Symptom FRU/action Not all drives are recognized by 1. Remove the first drive not recognized and try the hard disk drive the hard disk drive diagnostic diagnostic test again. test (Fixed Disk test). 2. If the remaining drives are recognized, replace the drive you removed with a new one. 110 xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide