IBM 8659-71Y Maintenance Manual - Page 163
No Beep Symptoms
![]() |
UPC - 087944526346
View all IBM 8659-71Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
No Beep Symptoms No Beep Symptom FRU/Action No beep and the system operates correctly. 1. Speaker 2. System Board No Beeps occur after successfully completing POST (The Power-On Status is disabled.) 1. Run Configuration/Setup, set the Start Options Power-On Status to enable. 2. Check speaker connection. 3. Speaker 4. System Board No AC power (Power supply AC LED is off) 1. Check the power cord 2. Power Supply (If two are installed, swap them to determine if one is defective.) 3. Hot Swap Power AC Inlet Box No beep and no video 1. See "Undetermined Problems" on page 165. No beep, fans running, and AC power LED blinking (System held in reset) 1. If an optional VRM is installed and no optional processor, remove the optional VRM. 2. If optional VRM failed, replace optional VRM. 3. If primary VRM failed, replace system board. 4. If system board failed, replace system board. Netfinity 5000 - Type 8659 155
![](/manual_guide/products/ibm-865971y-maintenance-manual-737f5fc/163.png)