IBM 8659-71Y Maintenance Manual - Page 42
Ethernet Controller Messages
![]() |
UPC - 087944526346
View all IBM 8659-71Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Ethernet Controller Messages The integrated Ethernet controller might display messages from the following device drivers: Novell NetWare or IntraNetWare Server ODI NDIS Adapter for level 2.01 (OS/2) NDIS Adapter for level 4.0 (Windows NT) SCO UNIX LLI Novell NetWare or IntraNetWare Server ODI Driver Messages: The following error messages are for the Novell NetWare or IntraNetWare server ODI driver. The explanation and recommended action are included with each message. PCNTNW-NW-026 The MSM is unable to parse a required custom keyword. Explanation: The user entered an incorrect parameter keyword. Action: Reload the driver using the correct keyword. PCNTNW-NW-054 The adapter did not respond to the initialization command. Explanation: The adapter did not respond when the driver tried to initialize it. Action: Verify that the PCI Ethernet device type is set to the default (enabled) setting in the Configuration/Setup utility programs (see "PCI Bus Control" on page 30). If the Ethernet adapter is enabled, go to "Diagnostic Test Programs" on page 11 to run the diagnostic utility. PCNTNW-NW-058 The adapter did not respond to the initialization command. Explanation: The interrupt request (IRQ) setting might not be valid or the EEPROM information might be incorrect. Action: Make sure the IRQ settings are correct in the Configuration/Setup utility programs. See "PCI Bus Control" on page 30 for information on setting the interrupt requests. If the IRQ settings are correct, replace the system board. PCNTNW-NW-066 The cable might be disconnected from the adapter. Explanation: The cable might be disconnected from the server Ethernet port. Action: Verify that a cable is connected to the Ethernet port. PCNTNW-NW-071 The matching virtual adapter could not be found. Explanation: You tried to load another instance of the driver with a different I/O address. This new adapter could not be found. Action: If you installed an Ethernet adapter, such as an IBM Netfinity 10/100 Fault Tolerant Adapter, as part of Ethernet redundancy (failover), make sure that the adapter is seated correctly. If the adapter is seated correctly, replace the adapter. PCNTNW-NW-072 A resource tag is unavailable. Explanation: The driver tried to allocate some resources that were not available. Action: Add or free some memory in the server. Then, restart the server. PCNTNW-NW-073 Unable to allocate memory. Explanation: The driver failed to allocate the memory needed for normal operation. Action: Add more memory, or free some memory resources in the server. Then, restart the server. 34 Netfinity Server HMM
![](/manual_guide/products/ibm-865971y-maintenance-manual-737f5fc/42.png)