IBM 866011U Hardware Maintenance Manual - Page 109

Using the ServeRAID Configuration program After the ServeRAID Configuration program starts, one of the following screens will appear: If you have more than one ServeRAID controller in the system, a screen similar to the following appears. Note You can install multiple ServeRAID adapters in the server, but you must configure each adapter separately. IBM ServeRAID Adapter Disk Array Configuration Utility Ver. X.XX Select Adapter 1. Help 2. ServeRAID Adapter 1 3. ServeRAID Adapter 2 4. Exit Multiple IBM ServeRAID Adapter found in the system. Select a choice using the Up Arrow ( ) and Down Arrow ( ) keys and press Enter. Note In the upper-right corner of the screen, you will see Ver. x.xx. On the screen, the x.xx is replaced by the version number of the configuration program. Use the Up Arrow (↑) or Down Arrow (↓) key to highlight your choice; then, press Enter. The Main Menu appears. If you have only one ServeRAID controller installed in the server, the Main Menu appears. IBM ServeRAID Adapter Disk Array Configuration Ver. X.XX Adapter Number: 1 Bus Number: 0 Host ID = Null Config Main Menu 1. Help 2. View Configuration 3. EZ-RAID Configuration 4. Create/Delete/Copy Log Drive 5. Initialize/Synchronize Log Dr 6. Rebuild/Device Management 7. Advanced Functions 8. Exit Select a choice using the Up Arrow ( ) and Down Arrow ( ) keys and press Enter. Press Esc to return to previous menu. Netfinity 5500 - Type 8660 101