IBM 866011U Hardware Maintenance Manual - Page 123

Hard Event displays the number of SCSI I/O processor events that occurred on the drive since the Device Event Log was last cleared. It also indicates if the drive exceeded the Predictive Failure Analysis (PFA) threshold. Notes 1. If a PFA event is detected, it appears beside the hard event information. 2. If the drive exceeded the PFA threshold, back up the RAID level 0 logical drives. Then, replace the drive. Parity Event displays the number of parity events that occurred on the SCSI bus since the Device Event Log was last cleared. Misc Event displays the number of other events (such as selection timeout, unexpected bus free, or SCSI phase event) that occurred on the drive since the Device Event Log was last cleared. 5. Press Esc to return to the Main Menu. Viewing or changing the ServeRAID controller parameters: You can use the ServeRAID Configuration program to view or change the ServeRAID controller parameters. To view or change the ServeRAID controller parameters: 1. Start the ServeRAID Configuration program (see "Starting the ServeRAID Configuration program" on page 77). 2. Select Advanced Functions from the Main Menu; then, press Enter. 3. Select Display/Change Adapter Params from the next menu; then, press Enter. A screen similar to the following appears. IBM ServeRAID Adapter Disk Array Configuration Ver. X.XX Adapter Number: 1 Bus Number: 0 Host ID = Null Config Display/Change Adapter Parameter 1. Help 2. Display Adapter Status 3. Change Adapter Host/SCSI ID 4. Set BIOS Compatability Mapping 5. Set Channel -> Bank Mapping 6. Exit Ch 1 Array Bay 1 ONL A 2 ONL A 3 ONL A 4 5 6 7 8 INI 9 10 11 12 13 14 15 16 Ch 2 Array Bay 1 HSP 2 ONL B 3 4 5 ONL B 6 RDY 7 CDR 8 INI 9 10 11 12 13 14 15 16 Select drive using the Up Arrow ( ) and Down Arrow ( ) keys. Press Esc to return to the previous menu. Descriptions of the choices available from this menu are as follows: Netfinity 5500 - Type 8660 115