IBM 866011U Hardware Maintenance Manual - Page 57

Unattended Mode Code Block Version Boot Block Version Concurrent Commands Maximum Devices Supported Flash Program Count Defunct Disk Count Rebuild Rate Hot-Swap Rebuild Offline Logical Drive Count Configuration Update Count Off - The user chooses the recovery method when there is a ServeRAID controller startup error. On - The ServeRAID controller chooses the recovery method when there is a startup error. The current version level of the firmware microcode for the ServeRAID controller. The current version level of the microcode loaded in the boot block for the ServeRAID controller. The maximum numbers of concurrent commands supported. The maximum number of devices supported. The number of times that the ServeRAID controller microcode (Flash EEPROM) has been flashed or updated. The current number of defunct hard disk drives. The setting for the rebuild rate can be low, medium, or high priority. (The default setting is high.) If hot-swap rebuild is set to enable, the ServeRAID controller will rebuild a defunct drive automatically when all of the following conditions exist: The hot-swap rebuild parameter is set to Enable The defunct drive is part of a RAID level 1 or RAID level 5 logical drive The capacity of the replacement drive is equal to or greater than the capacity of the defunct drive No rebuild, synchronization, or RAID level change operation is in progress When you replace the drive and these requirements are met, the ServeRAID controller automatically initiates a rebuild of the drive without user intervention. The current number of offline logical drives. The number of times that the ServeRAID controller configuration information has been updated. Netfinity 5500 - Type 8660 49