IBM 866441Y Hardware Maintenance Manual - Page 135
Termination internal SCSI devices, Preinstallation steps all bays, SCSI IDs
![]() |
UPC - 087944522201
View all IBM 866441Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
The device is attached to the integrated SCSI controller. SCSI IDs: Each SCSI device that is connected to an individual channel of a SCSI controller needs a unique identification (ID) so that the controller can identify the devices and ensure that different devices do not attempt to transfer data at the same time. If you need to set IDs for SCSI devices, refer to the instructions that come with those devices. The server automatically sets SCSI IDs for hot-swap hard disk drives. The SCSI ID assigned to each hot-swap bay is shown on the server beside the bay and in the illustrations in "Internal drive bays" on page 124. The server uses the hard disk drive SCSI IDs to send status information to the indicator lights above each hot-swap bay. The SCSI backplane in the server supports up to six hot-swap bays. The processing sequence for SCSI devices proceeds from the lowest SCSI ID to the highest (0 to 5, then 8 to 15). Termination (internal SCSI devices): SCSI buses must be terminated at each end. The ends of the SCSI buses in the server are already terminated. All the hot-swap drives in the server have automatic termination and the SCSI controller provides termination at the other end of the SCSI bus. You must disable termination on any SCSI devices that you install in the non-hot-swap bays. Refer to the information that come with the SCSI device for instructions about setting device jumpers or switches that control termination. Preinstallation steps (all bays): Before you install drives in the server, verify that you have all the cables and any other equipment specified in the documentation that comes with the internal drive. You might also need to perform certain preinstallation activities. Some of the steps are required only during the initial installation of an option. Before you begin: Read "Safety information" on page 230. Read the documentation that comes with the internal drive. 1. Choose the bay in which you want to install the drive. 2. Check the instructions that come with the drive to see if you need to set any switches or jumpers on the drive. Netfinity 5600 - Type 8664 127
![](/manual_guide/products/ibm-86644ry-hardware-maintenance-manual-70136a6/135.png)