Insignia IS-HC040917 User Manual (English) - Page 11
Connecting the Speakers, Speakers, Connecting the Main, Center, Rear Speaker, Speaker Polarity - parts
View all Insignia IS-HC040917 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Connecting the Speakers FRONT CENTER SPEAKER FRONT RIGHT SPEAKER FRONT LEFT SPEAKER RIGHT LEFT Getting Started Or you also may use banana plug. SUB WOOFER VIDEO Method 1 Method 2 Use this jack on the middle back panel to SW OUT connect another powered subwoofer other than the one supplied. RIGHT LEFT SURROUND CENTRE SURROUND RIGHT SURROUND LEFT SPEAKER SPEAKER SPEAKER MAKE SURE TO CONNECT 6-8 OHM SPEAKERS ONLY. Speaker Polarity When connecting the speakers, make sure the polarities ( "+" speaker wire to "+" on the receiver) of speaker wires and terminals are matched. If the cords are reversed, the sound will be distorted and will lack bass ("out of phase" effect). Speakers You will need to use 7 speakers with the unit (Front Left, Front Right, Front Center, Surround Left Surround center, Surround Right and subwoofer). In order to enjoy good surround effects all six speaker need to be connected to the receiver. At least two front speakers (Front left and right) are required. For better sound quality, Center speaker, Surround speakers and Subwoofer should also be connected. Adding Center and Surround speakers will enhance surround effects. Adding a Subwoofer will increase bass response. If you want to enjoy full range of sound effects, with small speakers,it is a must to use the subwoofer with the speakers to maintain adequate bass signal. Notes Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the speakers,or both. Connect the speakers terminals to your speakers with the wire of the wire of the proper gauge (keep as short as possible). if the connections are faulty. no sound will be heard from the speakers. Connecting the Subwoofer To connect your own powered subwoofer, a mono aural audio cord (not supplied) is needed (RCA terminal). Connecting the Main ,Center, Rear Speaker 1.Loosen the knob. 2.Insert the bare wire.[Remove approx 5mm(1/4 ) insulation from the speaker wires.] 3.Tighten the knob and secure the wire. This receiver offers a high flexibility for user to use a large variety of speakers and subwoofers. For more information please refer to section "Speaker Setting" in "Operating Your Receiver" on page 20. 10