Insignia NS-LTDVD19 User Manual (English) - Page 7
Setting up your LCD TV/DVD, combo - remote control
View all Insignia NS-LTDVD19 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Insignia NS-LTDVD19 19" LCD TV/DVD Combo Setting up your LCD TV/DVD combo Installing remote control batteries To install remote control batteries: 1 Remove the battery compartment cover. 3 Plug the other end of the cable into the outside antenna jack. Notes To improve picture quality in an area with poor signal reception, install a signal amplifier. If you want to connect two TVs to the antenna, install a 2-way signal splitter. Connecting cable or satellite TV To watch cable or satellite TV, you need a TV tuner device or a cable or satellite TV converter box. There are two ways to connect cable or satellite TV to your LCD TV/DVD combo. Option 1 2 Insert two AA batteries into the battery compartment. Make sure that you align the + and - symbols on the batteries with the + and - symbols inside the battery compartment. 3 Replace the battery compartment cover. Notes Make sure that there is no obstruction between the remote control and the remote sensor on your LCD TV/DVD combo. Keep the remote control away from heat sources or humid areas. Strong light may affect the signal between the remote control and the remote sensor on your LCD TV/DVD combo. If the remote control does not work, change the position of the remote control. Make sure that the batteries are alkaline batteries. Batteries must be of the same type. Do not mix old and new batteries. Do not use rechargeable batteries. Connecting an antenna Caution Do not bend the bronze wires on the cables. To connect an antenna: 1 Make sure that your LCD TV/DVD combo is turned off. 2 Plug one end of a 75 ohm cable (not included) into the ANT IN jack on the back of your LCD TV/DVD combo. Caution Do not bend the bronze wires on the cables. To connect cable or satellite TV: 1 Make sure that your LCD TV/DVD combo and converter box are turned off. 2 Connect a 75 ohm cable (not included) to the RF jack on the cable or satellite TV converter box and to the ANT IN jack on the back of your TV. 3 Connect one end of a 75 ohm cable (not included) to the cable jack on the cable or satellite TV converter box and to the cable or satellite TV wall jack. 4 Set the channel switch on the cable or satellite TV converter box to 3 or 4. 5 Turn on your LCD TV/DVD combo and the converter box, then tune your LCD TV/DVD combo to the same channel you set the channel switch to. 6 Use the cable or satellite TV remote control to tune channels. Option 2 To connect cable or satellite TV: 1 Make sure that your LCD TV/DVD combo and cable or satellite converter box are turned off. 2 Connect audio and video out jacks on the cable or satellite TV converter box to the AUDIO IN and VIDEO IN jacks on the back of your TV. 3 Turn on your LCD TV/DVD combo and the converter box, then press INPUT to select TV. www.insignia-products.com 5