Home » Intel Manuals » Motherboards » Intel D865GRH » Manual Viewer

Intel D865GRH D865GRH_TechProdSpec. - Page 45

LAN Subsystem - lan driver

Get Intel D865GRH PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

Product Description 1.10 LAN Subsystem The Gigabit (10/100/1000 Mbits/sec) LAN subsystem includes the GMCH (with its CSA interface), the Intel 82547EI PLC, and an RJ-45 LAN connector with integrated status LEDs. Additional features of the LAN subsystem include: • PCI bus master interface • CSMA/CD protocol engine • 8-bit CSA port interface that supports the 82547EI • PCI power management  Supports ACPI technology  Supports LAN wake capabilities 1.10.1 Intel® 82547EI Platform LAN Connect Device Intel 82547EI provides the following functions: • Basic 10/100/1000 Ethernet LAN connectivity • Communication Streaming Architecture (CSA) port provides higher throughput and lower latencies than the Intel® 82562EZ device, resulting in up to 30% higher bus throughput (up to wirespeed) • Full device driver compatibility • Programmable transit threshold • Configuration EEPROM that contains the MAC address 1.10.2 RJ-45 LAN Connector with Integrated LEDs Two LEDs are built into the RJ-45 LAN connector (as shown in Figure 12). Table 12 describes the LED states when the board is powered up and the Gigabit LAN subsystem is operating. Green LED Green/Yellow LED OM16513 Figure 12. LAN Connector LED Locations Table 12. LAN Connector LED States LED Left Color Green LED State Off On Blinking N/A Off Right Green On Yellow On Condition LAN link is not established. LAN link is established. LAN activity is occurring. 10 Mbits/sec data rate is selected. 100 Mbits/sec data rate is selected. 1000 Mbits/sec data rate is selected. 45

Section	Page
Intel® Desktop Board D865GRH Technical Product Specification	1
Revision History	2
Preface	3
Intended Audience	3
What This Document Contains	3
Typographical Conventions	3
Other Common Notation	4
Contents	5
1 Product Description	11
1.1 Overview	12
1.1.1 Feature Summary	12
1.1.2 Manufacturing Options	13
1.1.3 Board Layout	14
1.1.4 Block Diagram	15
1.2 Online Support	16
1.3 Operating System Support	16
1.4 Design Specifications	17
1.5 Processor	20
1.6 System Memory	21
1.6.1 Memory Configurations	23
1.7 Intel® 865G Chipset	28
1.7.1 Intel 865G Graphics Subsystem	29
1.7.2 Universal 0.8 V / 1.5 V AGP 3.0 Connector	37
1.7.3 USB	38
1.7.4 IDE Support	38
1.7.5 Real-Time Clock, CMOS SRAM, and Battery	40
1.8 I/O Controller	40
1.8.1 Serial Port	41
1.8.2 Parallel Port	41
1.8.3 Diskette Drive Controller	41
1.8.4 Keyboard and Mouse Interface	41
1.9 Audio Subsystem	42
1.9.1 Audio Subsystem Software	42
1.9.2 Intel® Flex 6 Audio Subsystem	42
1.9.3 Audio Connectors	44
1.10 LAN Subsystem	45
1.10.1 Intel® 82547EI Platform LAN Connect Device	45
1.10.2 RJ-45 LAN Connector with Integrated LEDs	45
1.10.3 LAN Subsystem Software	46
1.11 Hardware Management Subsystem	46
1.11.1 Hardware Monitoring and Fan Control ASIC	46
1.11.2 Thermal Monitoring	46
1.11.3 Fan Monitoring	48
1.11.4 Chassis Intrusion and Detection	48
1.12 Power Management	48
1.12.1 ACPI	48
1.12.2 Hardware Support	51
1.13 Trusted Platform Module	56
1.13.1 System Requirements	56
1.13.2 Warning of Potential Data Loss	56
1.13.3 Security Precautions	57
1.13.4 Trusted Platform Module Ownership	59
1.13.5 Enabling the Trusted Platform Module	59
1.13.6 Assuming Trusted Platform Module Ownership	60
1.13.7 Recovery Procedures	61
1.13.8 Clearing Trusted Platform Module Ownership	62
1.13.9 Software Support	62
2 Technical Reference	63
2.1 Introduction	63
2.2 Memory Resources	63
2.2.1 Addressable Memory	63
2.2.2 Memory Map	65
2.3 DMA Channels	65
2.4 Fixed I/O Map	66
2.5 PCI Configuration Space Map	67
2.6 Interrupts	68
2.7 PCI Interrupt Routing Map	69
2.8 Connectors	71
2.8.1 Back Panel Connectors	72
2.8.2 Internal I/O Connectors	73
2.8.3 External I/O Connectors	81
2.9 Jumper Blocks	85
2.9.1 Front Panel Audio Connector/Jumper Block	85
2.9.2 BIOS Setup Configuration Jumper Block	86
2.10 Mechanical Considerations	87
2.10.1 I/O Shield	88
2.11 Electrical Considerations	89
2.11.1 DC Loading	89
2.11.2 Add-in Board Considerations	89
2.11.3 Fan Connector Current Capability	89
2.11.4 Power Supply Considerations	90
2.12 Thermal Considerations	90
2.13 Reliability	93
2.14 Environmental	93
2.15 Regulatory Compliance	94
2.15.1 Safety Regulations	94
2.15.2 EMC Regulations	94
2.15.3 European Union Declaration of Conformity Statement	95
2.15.4 Product Ecology Statements	96
2.15.5 Product Certification Markings (Board Level)	96
3 Overview of BIOS Features	97
3.1 Introduction	97
3.2 BIOS Flash Memory Organization	97
3.3 Resource Configuration	98
3.3.1 PCI Autoconfiguration	98
3.3.2 PCI IDE Support	98
3.4 System Management BIOS (SMBIOS)	99
3.5 Legacy USB Support	99
3.6 BIOS Updates	100
3.6.1 Language Support	100
3.6.2 Custom Splash Screen	101
3.7 Recovering BIOS Data	101
3.8 Boot Options	102
3.8.1 CD-ROM Boot	102
3.8.2 Network Boot	102
3.8.3 Booting Without Attached Devices	102
3.8.4 Changing the Default Boot Device During POST	102
3.9 Fast Booting Systems with Intel Rapid BIOS Boot	103
3.9.1 Peripheral Selection and Configuration	103
3.9.2 Intel® Rapid BIOS Boot	103
3.10 BIOS Security Features	104
4 BIOS Setup Program	105
4.1 Introduction	105
4.2 Maintenance Menu	106
4.3 Main Menu	107
4.4 Advanced Menu	108
4.4.1 PCI Configuration Submenu	109
4.4.2 Boot Configuration Submenu	110
4.4.3 Peripheral Configuration Submenu	111
4.4.4 Drive Configuration Submenu	113
4.4.5 Floppy Configuration Submenu	117
4.4.6 Event Log Configuration Submenu	118
4.4.7 Video Configuration Submenu	119
4.4.8 USB Configuration Submenu	120
4.4.9 Chipset Configuration Submenu	121
4.4.10 Fan Control Configuration Submenu	124
4.4.11 Hardware Monitoring	125
4.5 Security Menu	126
4.6 Power Menu	127
4.6.1 ACPI Submenu	127
4.7 Boot Menu	128
4.7.1 Boot Device Priority Submenu	129
4.7.2 Hard Disk Drives Submenu	130
4.7.3 Removable Devices Submenu	130
4.7.4 ATAPI CD-ROM Drives Submenu	131
4.8 Exit Menu	131
5 Error Messages and Beep Codes	133
5.1 BIOS Error Messages	133
5.2 Port 80h POST Codes	135
5.3 Bus Initialization Checkpoints	139
5.4 Speaker	140