Intel D925XHY D925XHY Technical Product Specification - Page 21
Intel, 925X Chipset - drivers
View all Intel D925XHY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Product Description 1.5 Intel® 925X Chipset The Intel 925X chipset consists of the following devices: • Intel 82925X Memory Controller Hub (MCH) with Direct Media Interface (DMI) interconnect • Intel 82801FR I/O Controller Hub (ICH6-R) with DMI interconnect • Firmware Hub (FWH) The MCH is a centralized controller for the system bus, the memory bus, the PCI Express bus, and the DMI interconnect. The ICH6-R is a centralized controller for the board's I/O paths. The FWH provides the nonvolatile storage of the BIOS. For information about The Intel 925X chipset Resources used by the chipset Refer to http://developer.intel.com/ Chapter 2 1.5.1 USB The board supports up to eight USB 2.0 ports, supports UHCI and EHCI, and uses UHCI- and EHCI-compatible drivers. The ICH6-R provides the USB controller for all ports. The port arrangement is as follows: • Four ports are implemented with dual stacked back panel connectors adjacent to the audio connectors • Four ports are routed to two separate front panel USB connectors NOTE Computer systems that have an unshielded cable attached to a USB port may not meet FCC Class B requirements, even if no device is attached to the cable. Use shielded cable that meets the requirements for full-speed devices. For information about The location of the USB connectors on the back panel The location of the front panel USB connectors Refer to Figure 15, page 50 Figure 16, page 52 1.5.2 IDE Support The board provides five IDE interface connectors: • One parallel ATA IDE connector, which supports two devices • Four serial ATA IDE connectors, which support one device per connector 21