Intel SR1690WB Service Guide - Page 48

5. Remove the cover from the server and locate the DIMM sockets (see Figure 17). C E D A B AF003227 Figure 17. Installing the Memory 6. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the open position (see letter "A" in Figure 17). 7. Holding the DIMM by the edges, remove it from its anti-static package. 8. Position the DIMM above the socket. Align the two small notches in the bottom edge of the DIMM with the keys in the socket (see letter "B" in Figure 17). 9. Insert the bottom edge of the DIMM into the socket (see letter "C" in Figure 17). 10. When the DIMM is inserted, push down on the top edge of the DIMM until the retaining clips snap into place (see letter "D" in Figure 17). Make sure the clips are firmly in place (see letter "E" in Figure 17). 11. Replace the server's cover and reconnect the AC power cord. Removing DIMMs To remove a DIMM, follow these steps: 1. Observe the safety and ESD precautions at the beginning of this book. 2. Turn off all peripheral devices connected to the server. Turn off the server. 3. Remove the AC power cord from the server. 4. Remove the server's cover. 5. Gently spread the retaining clips at each end of the socket. The DIMM lifts from the socket. 6. Holding the DIMM by the edges, lift it from the socket, and store it in an anti-static package. 30 Intel® Server System SR1690WB Service Guide