Intel SR1690WB Service Guide - Page 52
Installing the Heat Sink(s), Replacing a Processor, IU Reference Heat sink Assembly
![]() |
UPC - 735858210980
View all Intel SR1690WB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Installing the Heat Sink(s) 1. If a protective film covers the thermal interface material (TIM) on the underside of the heat sink, remove the protective film. 2. Align heat sink fans to the front and back of the chassis for correct airflow. Airflow goes from front-to-back of chassis. 3. Each heat sink has four captive fasteners and should be tightened as shown. 4. Using a #2 Phillips* screwdriver, finger-tighten each fastener diagonally according to the white-circled numbers (see Figure 23). 5. Securely re-tighten each fastener again in the same order as performed in Step 4. 6. Attach fan power cable to server board as shown below. 3 C 2 B 1 4 A AF003295 Figure 23. IU Reference Heat sink Assembly 7. Reinstall and reconnect any parts you removed or disconnected to reach the processor sockets. 8. Replace the server's cover and reconnect the AC power cord. See the documentation that came with your server chassis for instructions on installing the server's cover. Replacing a Processor 1. Observe the safety and ESD precautions at the beginning of this book. 2. Turn off all peripheral devices connected to the server. Turn off the server. 34 Intel® Server System SR1690WB Service Guide
![](/manual_guide/products/intel-sr1690wb-service-guide-33a770e/52.png)