JVC DVP7U Instruction Manual - Page 76

76 EN USING THE REMOTE CONTROL UNIT (cont.) Automatic Editing To VCR Recording Start/ Stop Button Remote sensor START/STOP PAUSE R.A.EDIT ON/OFF VCR REC STBY 13 Rewind the tape in the camcorder to the beginning of the scene you want to edit and press PAUSE (9). 14 Point the remote control towards the VCR's remote sensor and press VCR REC STBY (79), or manually engage the VCR's Record-Pause mode. 15 Press START/STOP on the remote control. Editing proceeds as programmed, right through to the end of the last registered scene. ● When dubbing is IN OUT MODE 1 00: 25 ~ 02 : 05 -- 2 07 : 18 ~ 08 : 31 -- -- 3-- 03: 33 ~ 05 : 53 4 09 : 30 ~ 13 : 15 5 15 : 55 ~ 16 : 29 -- -- 6-- -- :-- ~ 7 ~ 8 ~ T I ME CODE 1 6 : 3 0 TOTAL 9 : 39 complete, the camcorder enters the Pause mode, and the VCR enters its Record-Pause mode. ● If you do not register an Edit-Out point, the tape will be dubbed all the way to the end automatically. ● If you operate the camcorder during automatic editing, the VCR will enter its Record-Pause mode and automatic editing will stop. 16 Engage the Stop modes for the camcorder and the VCR. To make the R.A.Edit counter display disappear, press R.A.EDIT ON/OFF on the remote control. NOTES: ● Pressing R.A.EDIT ON/OFF on the remote control clears all settings registered during Random Assemble Editing. ● When the editing cable is connected to the remote control's PAUSE IN connector during dubbing, make sure the remote control is pointed at the VCR's sensor, and the path between the two is unobstructed. ● Random Assemble Editing may not function properly when using a tape including several duplicated time codes. (੬ pg. 21)