JVC GR-D33 Instruction Manual - Page 11

Basic Recording NOTE: Before continuing, perform the procedures listed below: ● Power (੬ pg. 6) ● Loading A Cassette (੬ pg. 10) Push. POWER/CHARGE lamp Power Zoom Lever Power Switch Lock Button Recording Start/Stop Button VIDEO RECORDING EN 11 1 Remove the lens cap. 2 Open the LCD monitor fully. (੬ pg. 12) 3 Set the VIDEO/MEMORY Switch to "VIDEO". (GR-D93/73 only) 4 Set the Power Switch to "A" or "M" while pressing down the Lock Button located on the switch. ● The POWER/CHARGE lamp lights and the camcorder enters the Record-Standby mode. "PAUSE" is displayed. ● To record in LP (Long Play) mode, ੬ pg. 25, 26. 5 To start recording, press the Recording Start/Stop Button. The "T REC" appears on the display while recording is in progress. 6 To stop recording, press the Recording Start/Stop Button again. The camcorder re-enters the RecordStandby mode. NOTES: ● The image will not appear simultaneously on the LCD monitor and the viewfinder. ● If the Record-Standby mode continues for 5 minutes, the camcorder's power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor. ● LCD monitor/viewfinder indications: • When power is supplied from a battery: the " " battery indicator is displayed. (੬ pg. 43) • When power is supplied from an AC outlet: the " " battery indicator does not appear. ● When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. To avoid this, refer to "Recording From The Middle Of A Tape" (੬ pg. 13). ● To turn the beep sounds off, ੬ pg. 25, 27. ● For other notes, ੬ pg. 38. VIDEO RECORDING & PLAYBACK