JVC GR-D33 Instruction Manual - Page 14

14 EN VIDEO PLAYBACK MMENU/VOL. BLANK SEARCH Power Switch Lock Button VIDEO/MEMORY (GR-D93/73 only) 8 4/9 3 Speaker 5 Normal Playback 1 Load a cassette. (੬ pg. 10) 2 Set the VIDEO/MEMORY Switch to "VIDEO". (GR-D93/73 only) 3 Set the Power Switch to "PLAY" while pressing down the Lock Button located on the switch. 4 To start playback, press 4/9. 5 To stop playback, press 8. ● During Stop mode, press 3 to rewind, or 5 to fastforward the tape. To control the speaker volume Rotate the MMENU/VOL. Wheel towards "+" to turn up the volume, or towards "-" to turn down the volume. NOTES: ● The playback picture can be viewed in the LCD monitor, viewfinder or on a connected TV. (੬ pg. 17) ● For other notes, ੬ pg. 39. Still Playback Pauses during video playback. 1) Press 4/9 during playback. 2) To resume normal playback, press 4/9 again. ● If still playback continues for more than about 3 minutes, the camcorder's Stop mode is automatically engaged. ● When 4/9 is pressed, the image may not pause immediately while the camcorder stabilizes the still image. Shuttle Search Allows high-speed search in either direction during video playback. 1) During playback, press 5 for forward search, or 3 for reverse search. 2) To resume normal playback, press 4/9. ● During playback, press and hold 5 or 3. The search continues as long as you hold the button. Once you release the button, normal playback resumes. ● A slight mosaic effect appears on the display during Shuttle Search. This is not a malfunction. ATTENTION: During Shuttle Search, parts of the picture may not be clearly visible, particularly on the left side of the screen. Blank Search Helps you find where you should start recording in the middle of a tape to avoid time code interruption. (੬ pg. 13) 1 Load a cassette. (੬ pg. 10) 2 Set the VIDEO/MEMORY Switch to "VIDEO". (GR-D93/73 only) 3 Set the Power Switch to "PLAY" while pressing down the Lock Button located on the switch. 4 During Stop mode, press BLANK SEARCH. ● The "BLANK SEARCH" indication appears and the camcorder automatically starts reverse or forward search, then stops at the spot which is about 3 seconds of tape before the beginning of the detected blank portion. ● To cancel Blank Search midway, press 8. NOTES: ● Before starting Blank Search, if the current position is at a blank portion, the camcorder searches in the reverse direction. If the current position is at a recorded portion, the camcorder searches in the forward direction. ● Blank Search does not work if "USE CLEANING CASSETTE" has appeared with the tape. ● If the beginning or end of the tape is reached during Blank Search, the camcorder stops automatically. ● A blank portion which is shorter than 5 seconds of tape may not be detected. ● The detected blank portion may be located between recorded scenes. Before you start recording, make sure there is no recorded scene after the blank portion.