JVC GY-HD200UB GY-HD200U Owner's Manual - Page 77

PREPARATIONS About the Viewfinder Cable Attach the viewfinder cable to the clamp 7 on page 14. To reduce the emission of unwanted radio waves, be sure to attach the provided core filter as shown in the figure below. • Attach the core filter (black) as close to this device as pos- sible, as shown in the figure. Taking out the SD memory card 1. Push the SD memory card in the direction of the arrow. • The SD memory card comes out slightly. 2. Pull the SD memory card straight out. Core filter (black) Inserting an SD Memory Card By using an SD memory card, you can save and call up menu settings and camera settings for GY-HD250/GY-HD251. X See "FILE MANAGE Menu Screen" on page 100. Check that the POWER switch is OFF. Inserting an SD Memory Card 1. Open the SD memory card cover. 2. Face the cutout end of the SD memory card inward and insert it in the direction of the arrow. CAUTION Be sure not to touch the metal connector area of the SD memory card. 3. Close the SD memory card cover. About SD Memory Cards • When you use an SD memory card that was either just purchased or formatted on a device other than GY-HD250/ GY-HD251, format it on GY-HD250/GY-HD251. X See page 102. Recommended SD memory cards Panasonic: 16 MB to 2 GB • You can write-protect the card so that saved files are not mistakenly erased. Set the switch on the side of the SD memory card to the "LOCK" position. LOCK switch MEMO SDHC-compliant memory cards cannot be used with this device. Cutout 34 SD memory card cover Attaching the Tripod Base (Provided only for U model) Use the provided tripod base to place the camera on a tripod. (U model only) 1. Attach the tripod base on the tripod by using the hole that balances this device most optimally. CAUTION • The front base mount may be locked while the pin of the tripod base is not inserted into the hole on the rear base mount of this device. Therefore, after mounting, make sure that these parts are engaged properly. • When moving this device mounted on a tripod, any impact or vibration should be avoided as this may cause this device to become detached and to drop from the tripod. Be sure to remove this device from the tripod before transporting it. 1. Tripod mounting holes 2. While pushing the safety lever, pull the lock lever toward the front until the front mount clip clicks into place. Front mount clip 3. Pin 2. Safety lever 2. Lock lever 3. Place this device on the tripod base by aligning the rear base mount of this device with the pin on the tripod base. 4. Front base mount 3. Rear base mount 4. Hold the camera on the top and slide forward so that the base mount of the camera is locked by the front mount clip of this device as it clicks into place. 4. MACRO VF BRIGHT USER 1 USER 2 USER 3 ND FILTER 2 1 MENU STATUS WHT.BAL AUTO AUTO AUDIO CH-1 LEVEL CH-2 ON OFF POWER REC 35