JVC VN-C215VP4U Instruction Manual - Page 10
Name and Function of Parts
UPC - 046838030192
View all JVC VN-C215VP4U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Introduction Name and Function of Parts Camera unit A B C D E F K J I H G A Mounting hole ן2 Use these when mounting the base to the ceiling, wall or electrical box. (A Pg. 17)(A Pg. 21) Noteɿ ● To mount the camera using an electrical box, please check with your dealer or nearest JVC servicing center. B Holes for connection cable and piping This hole is for pulling out the connection cable. You can also use this hole to mount the camera directly on the piping. (Piping hole: G3/414UNC) (A Pg. 22) C Fall-prevention wire mounting screw This is used to mount the fall-prevention wire to the camera. (The fall-prevention wire is not supplied.) Noteɿ ● Connect the fall-prevention wire to prevent the camera from dropping. D Piping hole plug/Piping hole (side) This is used to mount the camera directly on the piping from the side. A piping hole plug is attached to this hole by default. (A Pg. 23) E Dome cover The dome cover is fragile. Take care when handling it. F Inner dome Before mounting the camera, remove it and perform image angle setting. (A Pg. 17) G Dome cover fastening screw These are fastening screws for the dome cover. H Base Mount the base to the ceiling, wall or electrical box before mounting the camera. (A Pg. 17)(A Pg. 21) 10