JVC VN-C215VP4U Instruction Manual - Page 25
Base GND cable connection, Warning - manual
![]() |
UPC - 046838030192
View all JVC VN-C215VP4U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Warning The rated power of this product is DC12 V. Make sure to use it with the correct voltage. Supplying a power different from the rated value may result in failures and in the worst scenario, smoking and fire. Memoɿ ● In a system where multiple units of VNC215VP4U are used, turn on the power of only 1 unit to configure the IP address settings via the Internet Explorer. Upon doing so, turn on the power of the second unit and configure accordingly. Configure the camera settings using the same procedure. ● Whenever duplication of IP addresses occurs, check that there is only one VNC215VP4U under the same LAN environment and wait for at least 10 minutes. Access to VN-C215VP4U may be denied unless you restore the power supply of all network devices under the same LAN environment. ● To use AA-P700 in the power supply unit, connect one unit of this product. Also refer to the AA-P700 instruction manual. Base GND cable connection To mount the camera to the base at a location insulated from the ground, connect DC12 V(Black) cable with the base GND cable (Purple). Wind the waterproof tape Base Base GND cable (Purple) Solder or crimp Insulation tape DC12 V- cable (Black) 25
![](/manual_guide/products/jvc-vnc215vp4u-instruction-manual-facbf33/25.png)