Kenmore 8027 Use and Care Guide - Page 30

I I PEDESTAL INSTALLATION List of Parts The following parts are included with the pedestal. • 18 screws for mounting • 4 dryer brackets • 1 adjusting wrench for leveling feet • 1 Phillips-head screwdriver • Installation instructions Tools Needed The following tools are needed for installation. • 1 #2 Phillips screwdriver • 1 adjusting wrench for leveling feet (included) To ensure safe and secure installation, please thoroughly follow the instructions below. WARNING" • Incorrect installation can cause serious accidents. • The appliances are heavy. Two or more people are required when installing the pedestal. There is a risk of serious back injury or other injuries. • Do not allow children to play in or on the drawer. There is a risk of suffocation or injury. • Do not step on the handle. There is a risk of serious injury. • If appliances are already installed, disconnect them from all power, water, or gas lines and from drain ing or venting connections. Failure to do so can result in electrical shock, fire, explosion, or death. • When installing, gloves must be put on. Retract fully li]) Make sure the leveling feet of the dryer are fully retracted. NOTE: The dryer and pedestal must be located on a solid, sturdy, level floor for proper operation. f T-clip O Insert the T-clip of the 4 retainers into the slots on the dryer base with the raised bracket toward the outside of the dryer. Press the back of the retainer upward while sliding the retainer toward the outside of the dryer to lock it in place. For d rye_. For washer/combo O Set the dryer in place on the pedestal. The dryer feet will align with the inner-most cut-outs in the pedestal brackets as shown. Dryers are large and heavy, so have someone help you lift it. J O Make sure the holes in the pedestal brackets align with the holes in the dryer retainers, then install two screws in each bracket. f Raise Lower O Loosen the Iocknuts on the pedestal feet with the wrench, then adjust the feet as shown above to level the dryer. Use a level, and make sure all 4 feet are solid and even on the floor. O Once the pedestal is adjusted and level, use the wrench to tighten the Iocknuts against the base of the pedestal to prevent the feet from vibrating out of adjustment. 30 I I