Kenwood C-V351 User Manual - Page 22

Playing music The following procedure allows to play a CD, MD, DVD or 22 cassette tape. Preparations ÷ Connect components as described in "System connection". 5 ÷ Complete "Setup of the Graphical Remote Control (GRC) unit". ! C-V351/C-V301 (EN) AV CONTROL CERTER KC-2 : Keys or controls to be used in this operation 1 Press the ON/STANDBY key to ON. Main unit RC POWER GRC ON/STANDBY 2 Select the input source. Main unit RC ON/STANDBY GRC INPUT INPUT 3 Play the selected source. Main unit RC 6 Operation on each source component Main Menu ENTER C D ENTER GRC CD ENTER ENTER 4 Adjust the volume. Main unit RC GRC VOLUME CONTROL To increase volume % To increase volume DOWN To decrease volume UP To increase volume VOLUME fi To decrease volume VOLUME To decrease volume ÷ Load the CD player, MD recorder, DVD player or cassette deck with the software to be played. \Read the instruction manuals of the associated components. With the main unit operation, the input sources are switched as shown below. 1 VCR 2 AUX 3 TAPE 1 / MD *1 4 TUNER (frequency display) 5 CD 6 LD / DVD *2 7 6ch INPUT *1: To change the TAPE 1 display to MD display *2: To change the LD display to the DVD display To enable system-control operation, the displayed information should be set according to the actually connected components. 0 ÷ Note for using the 6ch INPUT ∞ ÷ Step 3 can be omitted if the easy operation feature is available. ¡ One-touch operation Pressing the play key of the CD player, DVD player or cassette deck starts up the system automatically and starts playback. When this operation is used, steps 1 and 2 can be omitted. ¡ Volume level is displayed. V O L U M E - 5 ) dB ÷ The time taken till the volume level is displayed is variable depending on the current operating condition. ÷ Rotating the VOLUME CONTROL at a higher speed increases the amount of volume change (AI VOLUME function). ÷ The sound of input source cannot be listened to while TAPE 2 (MONITOR) is ON.