Kenwood C-V351 User Manual - Page 29

The AUTO MEMORY function gives precedence to RDS stations and assigns them from preset number 1. Therefore, when it is required to preset RDS stations as well as non-RDS stations, execute the AUTO MEMORY operation first then proceed to the manual memory operation of non-RDS stations. Preparation ÷ Select the TUNER input. & ÷ Display the Tuner operation menu. & RDS (Radio Data System) C-V351/C-V301 (EN) Order of radio station presetting 29 Other stations than the RDS stations can be stored in the preset memory by presetting them after the RDS stations preset by AUTO MEMORY as shown below or overwriting the RDS stations preset in some preset numbers. Preset number 1 2 39 40 1 AUTO MEMORY RDS stations (~ FM stations) 2 Manual memory ~ FM stations or LW or MW stations Storing radio stations manually in preset memory RC GRC 1 Select the receiving band. 2 Select a station or frequency. 3 Press the Memory key during receiving a station. MEMO AUTO MEMORY Memory / 10key Pad Proceed to step 4 within 10 sec. (If more than 10 sec. have elapsed, press the Memory key again.) ENTER Memory ENTER 4 Select one of the preset numbers from 1 to 40. PTY SEARCH +10 1 2 3 4 5 6 7 8 9 0 123 456 789 0 +10 ENTER Receiving a preset station ÷ Apart from the auto memory function, RDS stations can also be stored manually in the preset memory. ÷ In the manual memory storage operation of radio stations, it may take a few minutes after the Memory key is pressed till the memory display starts to blink depending on the receiving condition. Lights up (for 10 sec.) Blinks (for 10 sec.) ) - MEMO FM 8 9; ) ) MHz Press the numeric keys in the following order:... (RC) To store in "15" ....... 0, 5 Press the numeric keys in the following order:... (GRC) To store in "15" ....... 0 ENTER 5 ENTER ÷ Repeat steps 1,2,3,4 for each of the stations to be stored in memory. ÷ If a station is stored in a preset number which has already stored a station memory under it, the previous memory is replaced by the new memory content. ÷ If RDS stations are stored manually in the preset memory, the PS may not be included in the memory depending on receiving conditions. RC 1 2 6 7 GRC Enter the preset number (max. 40) of the desired station. PTY SEARCH +10 3 4 5 8 9 0 Memory / 10key Pad ENTER 123 456 789 0 +10 ENTER Press the numeric keys in the following order:...(RC) To recall "15 0, 5 Press the numeric keys in the following order:...(GRC) To recall "15 0 ENTER 5 ENTER ÷ If you make a mistake in entering the figure of 10, press the 0 key repeatedly until the original display is shown, then enter the correct number. Preset number stored in memory 1 5 FM 8 9; ) ) MHz Receiving all preset stations in order (P. CALL) RC GRC The preset number decreases. The preset number increases. P.CALL fi % PTY TA/NEWS/INFO. The preset number decreases. The preset number increases. P.Call 01ch ENTER ÷ Every time the key is pressed, the next station in the order of the preset number is received. When you press P.Call key When you press 1 2 3 P.Call key 38 39 40 1 2 3 38 39 40 If the key is held pressed Preset stations will be received successively for about half a second each.