Kenwood C-V351 User Manual - Page 55
Memory backup function, In case of difficulty, Remote control unit, Set up code chart
View all Kenwood C-V351 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
In case of difficulty C-V351/C-V301 (EN) 55 Remote control unit Symptom Remote control operation is not possible. The GRC screen is not displayed. The GRC display is abnormal. Cause ÷ Batteries are exhausted. ÷ The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle in between. ÷ The audio cords and system control cords are not connected properly. ÷ The source component to be operated does not contain the tape(s) or disc. Remedy ÷ Replace with new batteries. @) ÷ Operate the remote control unit within the controllable range. ! ÷ Connect properly referring to "System con- nection". 57 ÷ Place the tape(s) or disc in the source compo- nent to be played. ÷ Batteries are exhausted. ÷ Replace with new batteries. @ ÷ Batteries are removed while something is dis- ÷ Remove and replace batteries after the infor- played. mation display has disappeared. Set up code chart Although each setup code is designed to work with a number of different models, certain codes may not work with some models. (Also, certain codes may only operate some of the functions available on a given model.) With some models, be sure to keep the ENTER key pressed for a while. Memory backup function Please note that the following items will be deleted from this unit's memory if the power cord is disconnected from the AC outlet for approximately three days. ÷ The input selection is cleared and the TUNER input is selected. ÷ The volume setting is cleared and the volume is set to -65 dB. ÷ The receiving band setting is cleared and the FM band is selected. ÷ The frequency setting is cleared and 87.5 MHz is selected. ÷ The preset station memory is cleared. ÷ The voice activation setting is cleared and the activation by non- specified person is set. ÷ The surround setting is cleared and reset to the initial condition. ÷ The clock and timer setup is cleared and the clock display shows AM 12:00 which is blinking.