Kenwood TS-590SG Operation Manual - Page 15
Lcd Display
![]() |
View all Kenwood TS-590SG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
LCD DISPLAY A B C GETTING ACQUAINTED 2 D E F -- A -- While receiving, the meter serves as an S-meter to measure and display the received signal strength. While transmitting, it serves as a power meter plus an ALC meter, an SWR meter, or a Speech Processor compression meter. While adjusting the IF filter bandwidth, the meter displays an adjustment state {page 12}. -- B -- Appears when the Auto Mode function is ON and while in Auto Mode frequency setup {page 53}. Displays the operating mode (USB, LSB, FM, AM, CW, CWR, FSK, or FSR) {page 11}. Appears while in Menu mode {page 14}. Appears while in Memory Scroll mode {page 44}. Appears while in Memory Channel mode or Memory Scroll mode {page 44}. In normal operating mode and various configuration modes, it displays the Memory Channel number, Quick Memory number, and entry log number. In Menu mode, it displays the Menu No. -- C -- Appears while in Data mode {page 11} and while in Morse Code Decoder mode {page 38}. Appears while in narrow FM mode {page 11}. Appears when the receiver pre-amplifier is ON {page 42}. Appears when the receiver's attenuator is ON {page 42}. Appears when the Noise Blanker 1 or 2 is ON {page 42}. " " (fast) or " " (slow) appears when the Automatic Gain Control function is ON. " " appears when the AGC is OFF {page 30}. Appears when IF filter A is selected {page 40}. Appears when IF filter B is selected {page 40}. -- D -- " " appears when manual notch is set to Normal. " " appears when Manual Notch is set to Wide. " " appears when Auto Notch is selected {page 41}. Appears when the Fine Tuning function is ON {page 30}. Appears when the MHz Step function is ON {page 29}. Also appears when the Quick Menu function is ON {page 14}. " " or " " appears, depending on whether DSP Noise Reduction 1 or Noise Reduction 2 is selected {page 41}. " " appears when the RX Equalizer function is ON {page 57}. " " appears when the TX Equalizer function is ON {page 33}. " " or " " appears, when you select the DSP Beat Cancel 1 or Beat Cancel 2 {page 41}. " " appears when the Tone function is ON {page 26}, and blinks during Tone scan. " " appears when the CTCSS (Continuous Tone Coded Squelch System) function is ON, and blinks during CTCSS scan {page 27}. " " appears when the Cross Tone function is ON {page 28}. 7
![](/manual_guide/products/kenwood-ts590sg-operation-manual-634c406/15.png)