Kenwood TS-590SG Operation Manual - Page 65

No. Function Remark 134 DRV Selected ANT: ANT OUT on/off 135 METER 136 LSB/USB 137 CW/FSK Press and hold: REV 138 FM/AM Press and hold: NAR 139 DATA When the CW Morse decoder is ON, press and hold: enter the threshold level adjustment mode. 140 F.LOCK 141 FINE 142 IF FIL Press and hold: enter the bandwidth display. 143 NB Press and hold: enter the level setup mode. 144 NR Press and hold: enter the level setup mode. 145 AUTO NOTCH 146 BC 147 NOTCH Press and hold: NOTCH WIDE. 148 SPLIT Mic [PF2] default 149 TF-SET 150 A=B 151 A/B Mic [PF1] default 152 M/V 153 M.IN 154 M>V Mic [PF3] default 155 Q-M.IN 156 Q-MR 157 MHz 158 SCAN 159 MENU 160 CH1 161 CH2 162 CH3 163 CH4 164 RX 165 RIT [RIT] default 166 XIT [XIT] default 167 CL [CL] default 168 AGC/T Press and hold: enter the tone setup mode. 169 AGC OFF 170 CW T. 200 VOICE1 [PF A] default 201 VOICE2 [PF B] default OPERATOR CONVENIENCES 12 No. Function 202 VOICE3 203 MONITOR 204 TX TUNE 1 205 TX TUNE 2 206 DATA SEND 207 DWN 208 UP 209 EMERGENCY 210 OFF MUTE (SUB RECEIVER) Remark The lower meter when transmitting Mic [PF4] default The input voice from the data terminal is transmitted Mic [DWN] default Mic [UP] default Emergency frequency call (K type only) No function Note: ◆ Assigned key functions may not work, depending on the setting. ◆ [AGC SEL] can be used in modes other than FM mode, and can set a step level of the chosen AGC time constant (FAST/ SLOW). ◆ [TONE SEL] can also be used in FM mode while TONE or CTCSS is ON. DSP RX EQUALIZER EQUALIZING RECEIVING AUDIO Use Menu No. 37 to change the receiver frequency responses of the target signal. You can select one from 8 different receiver profiles including the default flat response. Selecting any of the following items from the Menu causes " " to appear on the display. • Off (oFF): Slightly attenuates (1 kHz or higher audio frequencies). • High boost 1 (hb1): Emphasizes higher audio frequencies. • High boost 2 (hb2): Emphasizes higher audio frequencies but lower audio frequency attenuation is less than High boost1 (hb1). • Formant pass (FP): Improves clarity by suppressing audio frequencies outside the normal voice frequency range. • Bass boost 1 (bb1): Emphasizes lower audio frequencies. • Bass boost 2 (bb2): Emphasizes lower audio frequencies but higher audio frequency attenuation is less than Bass boost1 (bb1). • Flat (FLAT): The flat frequency response. • User (U): Reserved for the ARCP software. Off is programmed at the factory as a default. Note: The RX Equalizer can be set for each mode. 57