Kenwood XD-752 User Manual - Page 33

To pause recording (Main unit only) Lights REC/ARM XD-7...series XD-6...series XD-8...series ÷ Pressing the key pauses recording after leaving a non-recorded space of about 4 seconds. ÷ If the key is pressed again in less than 4 seconds after it has been pressed, recording resumes from that instant. Selection of the reverse mode (Main unit only) REV. MODE Each press switches the modes as follows. 1 " " .... Recording stops after having recorded both sides of tape. 2 " " ... Recording stops after having recorded both sides of tape. 3 " " ..... Recording stops after having recorded one side of tape. ÷ When the "2" transport direction indicator is lit, recording always stops after having recorded one side of tape. Let's record 33 XD-SERIES (EN/M,T) Selection of DOLBY NR (Noise Reduction) (Main unit only) (XD-7...series, XD-8...series only) The DOLBY NR system minimizes the hiss noise heard when playing tape. When playing a tape prerecorded with DOLBY NR ON, be sure to set the DOLBY NR ON for playback. Lit when "DOLBY NR" is ON. DOLBY NR Each press switches the modes as follows. 1 "1 NR" ON .... DOLBY NR is used. 2 "1 NR" OFF ... DOLBY NR is not used. ÷ Select the DOLBY NR mode according to the recording condition of the tape. Dolby noise reduction manufactured under license from Dolby Laboratories. "DOLBY" and the double-D symbol are trademarks of Dolby Laboratories. Basic section Select an input source other than "TAPE". INPUT 4 REC/ARM 5 4. Select the source to be recorded. 1 TUNER (Radio) 2 CD 3 TAPE (This source cannot be recorded.) 4 MD/DVD (External input) (Input level adjustment Q) CD01 1:12 The input source component to be recorded should be displayed. ÷ If a disc has already been loaded when the CD input is selected, it will starts to play automatically. In this case, press the stop (&) key to stop it. 5. Start recording. 1 Start recording. 2 Play (or tune) the input source to be recorded. Lights XD-7...series XD-8...series XD-6...series ÷ Even if deck A is selected, it is automatically switched to deck B at the start of recording. ÷ Recording stops automatically when the tape side(s) to be recorded have been fully recorded. ÷ Press the stop (&) key of the cassette deck unit to stop recording.