Kenwood XD-752 User Manual - Page 66

66 No station can be received by preset call operation. Demonstration starts suddenly. ÷ The frequency of the preset station is not tunable. ÷ The preset memory has been cleared because the power cord has been unplugged for a long period. ÷ The power plug was unplugged from the outlet while the power switch was ON, or there was a power failure. In case of difficulty XD-SERIES (EN/M,T) ÷ Preset stations with tunable frequen- ⁄ cies. ÷ Preset stations again. ⁄ \ ÷ This is not malfunction. Press the 6 DISPLAY/DEMO key to cancel the demontration. Power turns OFF in the ÷ "A.P.S. on" is set. middle of operation. ÷ Set the "A.P.S. off". „ "Tape Dubbing" is not displayed in the menu. (XD-6...series, XD-8...series only) ÷ The DSP play or surround play pattern is selected. ÷ Select other equalizer pattern than the E DSP play and surround play patterns. Cassette deck Symptom Sound cannot be produced by pressing the play key. Cause ÷ The head is dirty. ÷ The tape is wound too tight due to irregular winding. ÷ A nonrecorded tape is played. Remedy ÷ Clean the head referring to "Mainte- ‰ nance". ÷ Try another tape. ÷ Play a recorded tape. No operation occurs even when an operation key is pressed. ÷ The cassette holder is not closed completely. ÷ The operation key is pressed immediately after closing the cassette holder. ÷ The operation key is pressed in less than 4 seconds after turning the power ON. ÷ A tape is not inserted in the unit. ÷ The tape is wound too tight due to irregular winding. ÷ The tape is fully wound to one of the reels. ÷ Close the holder completely. § ÷ Press operations keys in more than a few seconds after closing the holder. ÷ Press operation keys after waiting for more than 4 seconds. ÷ Insert a tape. ÷ Try another tape. § ÷ Change the tape transport direction or § reverse the tape insertion orientation. • The DPSS malfunctions. ÷ The tape used is not suitable for DPSS, ÷ Refer to "Searching for the desired ª (XD-7...series, XD-8...series for example the spaces between tunes music program (DPSS)". only) may be too short. In dubbing, the tape stops ÷ This is due to the difference in the ÷ Small time difference does not mean at different moments in tape length or characteristics of the a malfunction. decks A and B. mechanisms of two cassette decks. The cassette holders cannot be opened by pressing the 0 PUSH OPEN area. ÷ The key is pressed during recording or playback. ÷ The microcomputer is malfunctioning due to external noise. ÷ Press in stop mode. ÷ Reset the microcomputer. ˇ Sound is harsh or high fre- ÷ The head is dirty. quencies are not repro- duced. ÷ The tape is stretched or shrunk. ÷ Clean the head referring to "Mainte- ‰ nance". ÷ Try another tape. Knowledge section 1.With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape Notes protection function, and not a malfunction. 2.Do not use longer tape than 110 minutes tapes, for the tape is too thin and gets easily tangled.