Kenwood XD-752 User Manual - Page 35

Copying tape (Tape dubbing) The contents of the tape in deck A can be copied onto the tape in deck B. Let's record 35 XD-SERIES (EN/M,T) Load tapes in the decks. A Playing tape A Recording tape 5 Use the same tape transport directions. ÷ When recording is started, the tape will be transported in the direction selected in this step. ( > :side A, < : side B) 1 Select the "TAPE" input. INPUT 2 Press the stop key. & #¡ (1) Select the transport direction of deck A. MULTI CONTROL +Scrolled display (Deck A Play Direction) Deck A Pla SELECT A deck > #¡ 3 Select " " (double-side recording) or " " (one-side recording). ‹ REV. MODE 4 Select "Tape Dubbing". MENU MULTI CONTROL SELECT (2) Select the transport direction of deck B. MULTI CONTROL +Scrolled display (Deck B Record Direction) Deck B Rec SELECT B deck > The following items can be selected by turning the MULTI CONTROL jog dial. "Recording Options" "Tape Dubbing" "Audio Options" "Clock Options" "Surround Setup" (Except for XD-7...series) +Scrolled display (Tape Dubbing) Lights Tape Dubbi 6 Start dubbing. +Scrolled display (Press 'ENTER' to Start) Press 'ENT ENTER ÷ Dubbing ends automatically when the side(s) to be dubbed has been completed. Basic section XD-6...series, XD-8...series : ÷ "Tape Dubbing" cannot be selected during DSP or surround playback. In these modes, select another equalizer pattern and retry. E The DOLBY NR or TAPE EQ. key is ineffective during dubbing. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on deck A. To stop dubbing REC/ARM ÷ The deck B will stop after creating a non-recorded portion of about 4 sec, and then the deck A will stop. ÷ Dubbing can also be stopped by pressing the stop (&) key of the cassette deck unit. Note that the nonrecorded space is not created in this case.