KitchenAid KRFC704FSS Use & Care Guide - Page 14

4. Now you are ready to connect the copper tubing to the shut-off valve. Use 1⁄4" (6.35 mm) O.D. (outside diameter) soft copper tubing to connect the shut-off valve and the refrigerator. ■■ Ensure that you have the proper length needed for the job. Be sure both ends of the copper tubing are cut square. ■■ Slip compression sleeve and compression nut onto copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten. A B C A. Compression sleeve C. Copper tubing B. Compression nut 5. Place the free end of the tubing into a container or sink and turn on main water supply to flush out tubing until water is clear. Turn off shut-off valve on the water pipe. NOTE: Always drain the water line before making the final connection to the inlet of the water valve to avoid possible water valve malfunction. 6. Bend the copper tubing to meet the water line inlet which is located on the back of the refrigerator cabinet as shown. Leave a coil of copper tubing to allow the refrigerator to be pulled out of the cabinet or away from the wall for service. Connect to Refrigerator Follow the connection instructions specific to your model. 1. Remove plastic cap from water valve inlet port. Attach the copper tubing to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on copper tubing. 2.  Create a service loop with the copper tubing. Avoid kinks when coiling the copper tubing. Secure copper tubing to refrigerator cabinet with a "P" clamp. A B Complete the Installation WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. 2. Flush the water system. See "Water and Ice Dispensers" section. NOTE: Allow 24 hours to produce the first batch of ice. Discard the first 3 batches of ice produced. Allow 3 days to completely fill the ice storage bin. Handle Installation and Removal Parts Included: refrigerator door handles (2), refrigerated drawer handles (2), freezer drawer handle (1), 1⁄8" hex key, spare setscrew(s) NOTE: The freezer drawer handle is shorter than the refrigerator door handles. Handle style may vary by model. Install Handles Refrigerator Doors NOTE: Handle mounting setscrews are preinstalled inside the handle. 1.  Remove the handles from the packaging inside the refrigerator and place them on a soft surface. 2. Open a refrigerator compartment door. On the closed door, place a handle onto the shoulder screws so that the setscrews are facing the adjacent door. C D A B A. Copper tubing B. "P" clamp C. Compression nut D. Compression sleeve 3.  Turn on water supply to refrigerator and check for leaks. Correct any leaks. 14 A. Shoulder screws B. Setscrews inside the handle