KitchenAid KRFC704FSS Use & Care Guide - Page 15
Freezer Drawer
View all KitchenAid KRFC704FSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3. Firmly push the handle toward the door until the handle base is flush against the door. 4. While holding the handle, insert the short end of the hex key into the upper hole and slightly rotate the hex key until it is engaged in the setscrew. 5. Using a clockwise motion, tighten the setscrew just until it begins to contact the shoulder screw. Do not fully tighten. 6. Repeat steps 4 and 5 to fasten the lower setscrew. 7. Once both setscrews have been partially tightened as instructed in the previous steps, fully tighten both setscrews. IMPORTANT: When the screws feel tight, tighten them an additional quarter turn. The handle is not properly installed without this extra tightening. 8. Repeat steps 2 through 7 to install the other handle onto the adjacent refrigerator door. Freezer Drawer 1. With the drawer closed, place the handle onto the shoulder screws so that the setscrews are facing down toward the floor. A B 4. Using a left-to-right motion, tighten the setscrew a quarter turn at a time just until it begins to contact the shoulder screw. Do not fully tighten. 5. Repeat steps 3 and 4 to fasten the right-hand setscrew to the shoulder screw. 6. Once both setscrews have been partially tightened as instructed in the previous steps, fully tighten both setscrews. IMPORTANT: When the screws feel tight, tighten them an additional quarter turn. The handle is not properly installed without this extra tightening. 7. Save the hex key and all instructions. Remove the Handles 1. While holding the handle, insert the short end of the hex key into a setscrew hole and slightly rotate the hex key until it is engaged in the setscrew. 2. Using a right-to-left motion, loosen the setscrew a quarter turn at a time. 3. Repeat steps 1 and 2 for the other setscrew. Slowly pull the handle away from the door or drawer. 4. If necessary, use a Phillips screwdriver to remove the shoulder screws from the door. Remove and Replace Handle Medallions (optional) The handles for your model have red medallions on the ends. Replacement medallions are available for purchase. See "Accessories" to order. 1. Using a ¹⁄8" hex key, remove the medallion from the end of the handle. 2. Replace medallion. 3. Using the fastener removed in Step 1, attach the medallion to the handle. A. Shoulder screw B. Setscrews inside the handle 2. Firmly push the handle toward the drawer until the handle base is flush against the drawer. 3. Insert the short end of the hex key into the left-hand hole and slightly rotate the hex key until it is engaged in the setscrew. A A. Handle medallion 15