KitchenAid KRFC704FSS Use & Care Guide - Page 17

Filters And Accessories

Get KitchenAid KRFC704FSS PDF manuals and user guides View all KitchenAid KRFC704FSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

4. Remove the water filter cap from the water filter. FILTERS AND ACCESSORIES Water Filtration System Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. Replace and Install the Water Filter The water filter should be replaced every 6 months based on a flow rate of .50 gpm-.60 gpm that filters 200 gallons of water. To order a replacement filter, contact us. See "Accessories" section in the User Guide for information on ordering. NOTE: If the filter is not installed correctly, water may dispense at a lower flow rate and there will be slower ice production. Improper filter installation may also cause the water filter housing to leak. 1. Push the water filter door to open, located bottom left of refrigerator compartment. 5. Install the water filter cap onto the new filter. Be sure to align the arrows so the groves in filter align with ribs in filter cap. 6. Insert the filter into the housing. 2. Twist the water filter and turn 90° counterclockwise to unlock. 7. Twist the water filter and turn 90° clockwise until it locks into place and that arrows are aligned. 3. Pull the filter out of the housing. 8. Push the water filter door closed. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
17
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Replace and Install the Water Filter
The water filter should be replaced every 6 months based on a
flow rate of .50 gpm—.60 gpm that filters 200 gallons of water.
To order a replacement filter, contact us. See “Accessories”
section in the User Guide for information on ordering.
NOTE:
If the filter is not installed correctly, water may dispense
at a lower flow rate and there will be slower ice production.
Improper filter installation may also cause the water filter housing
to leak.
1.
Push the water filter door to open, located bottom left of
refrigerator compartment.
2.
Twist the water filter and turn 90° counterclockwise to unlock.
3.
Pull the filter out of the housing.
4.
Remove the water filter cap from the water filter.
5.
Install the water filter cap onto the new filter. Be sure to align
the arrows so the groves in filter align with ribs in filter cap.
6.
Insert the filter into the housing.
7.
Twist the water filter and turn 90° clockwise until it locks into
place and that arrows are aligned.
8.
Push the water filter door closed.
FILTERS AND ACCESSORIES
Water Filtration System