KitchenAid KRFC704FSS Use & Care Guide - Page 25

■■ Touch and hold CUBED ICE for 3 seconds to unlock the dispenser. ■■ The display screen indicates when the dispenser is locked. Ice Maker and Storage Bin IMPORTANT: To avoid low ice production and poor quality ice, flush the water system before turning on the ice maker. See "Water Dispenser" section. ■■ Following installation, allow 24 hours to produce the first batch of ice. Discard the first 3 batches of ice produced. Allow 2 to 3 days to fill the ice storage bin. ■■ The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well-maintained. ■■ If the ice in the storage bin clumps together, break up ice using a plastic utensil and discard ice. Do not use anything sharp to break up the ice. This can cause damage to the ice bin and the dispenser mechanism. ■■ Do not store anything in the ice storage bin. Ice Maker in the Refrigerator The ice maker is located on the left door behind the bins. Ice cubes are ejected into the ice storage bin located on the lefthand refrigerator door. Turn the Ice Maker On/Off 1. Push up on the latch on the left-hand side of the ice compartment to open the door. 3. Close the ice compartment door. Remove and Replace the Ice Storage Bin ■■ Remove the ice storage bin by inserting your fingers into the hole at the base of the bin and pulling the latch to release the bin from the compartment. Lift the storage bin up and pull it straight out. ■■ Replace the storage bin inside the ice compartment and push down to make sure it is firmly in place. Ice Production Rate ■■ The ice maker should produce approximately 3 lbs (1.4 kg) of ice per day under normal operation. ■■ To increase ice production, select the "Fast Ice" feature from the control panel. See "Using the Controls" section. Shelves, Bins, and Drawers Slide-Away Split Shelf Some shelves will tuck away to create room for taller objects. 1. To retract the front section of the shelf, push the adjustable portion of the shelf as far back as needed toward the rear of the refrigerator. 2. Extend the front glass and front trim of the shelf by pulling the retracted portion of the shelf outward until it is fully extended. 2. Turn on the ice maker by moving the switch to the On (I) position. NOTES: ■■ To manually turn off the ice maker, move the control to the Off (O) position. ■■ Your ice maker has an automatic shutoff. The sensor will automatically stop ice production if the storage bin is full, if the door is open, or the storage bin is removed. The control will remain in the On (up) position. 25