Konica Minolta bizhub 160 bizhub 160 User Guide - Page 81
Utility Mode, Specifying the Machine Settings
View all Konica Minolta bizhub 160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
5 5.1 Utility Mode There are four menus in the Utility mode. 5.1 Utility Mode No. Name Description 1 MACHINE SETTING Used to specify settings for the machine's operating environment. 2 PAPER SOURCE SETUP Used to specify the size and type of paper loaded in Tray1. In addition, auto tray switching can be enabled for each tray. 3 USER MANAGEMENT Used to specify settings after the drum cartridge is replaced. 4 COPY SETTING Used to specify the default settings for each copy function. 5 NETWORK SETTING Available only if the optional Network Interface Card NC-501 is installed. For details, refer to the User's Guide for the Network Interface Card NC-501. 5.2 Specifying the Machine Settings From the "MACHINE SETTING" menu, various settings for the machine's operating environment can be specified. Refer to the following table for details on each function. Using the Utility Mode Chapter 5 No. Name Description 1 AUTO PANEL RESET Whether the Auto Panel Reset function is disable or the time (0.5 min, 1 min, 2 min, 3 min, 4 min, or 5 min) until the machine is reset after finishing copying/printing or after performing the last operation can be selected. If the Auto Panel Reset function is enabled, all functions are automatically reset to their default settings. • The factory default setting is 1 min. 2 ENERGY SAVE MODE If the machine performs no operations for a set length of time, it will automatically enter the Energy Save mode. The length of time until the machine enters Energy Save mode can be set between 1 and 240 min (in 1 min increments). • The factory default setting is 15 min. 3 DENSITY (ADF) The scanning density when using the Automatic Document Feeder can be adjusted. Mode 1: For printing lighter copies of dark documents to avoid darkening of copies. Mode 2: For printing copies with same density as documents. • The factory default setting is "Mode 1". 4 DENSITY (BOOK) The density when scanning from the Original Glass can be adjusted. Mode 1: For printing copies with same density as documents. Mode 2: For printing lighter copies of dark documents to avoid darkening of copies. • The factory default setting is "Mode 1". 5 PRINT DENSITY The copy/print density can be adjusted to one of six levels between -3 and +2. With the normal print density at 0, choose a smaller number for a lighter print or choose a higher number for a darker print. • The factory default setting is "0" (Normal). 6 LCD CONTRAST The brightness of the display can be set to one of four levels between -1 and +2. • The factory default setting is "0" (Normal). 5-2 bizhub 160