Lantronix XPort Pro XPort Pro - User Guide - Page 107
TCP Settings, To con the TCP network protocol:
View all Lantronix XPort Pro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
12: Maintenance and Diagnostics Settings TCP Settings To configure the TCP network protocol: 1. Select Protocol Stack on the menu bar. 2. Select TCP. Figure 12-4 TCP Protocol 3. Modify the following settings: Protocol Stack TCP Settings Send RSTs Ack Limit Send Data Max Retrans Table 12-5 TCP Protocol Settings Description Click Enabled to send RSTs or Disabled to stop sending RSTs. TCP contains six control bits, with one or more defined in each packet. RST is one of the control bits. The RST bit is responsible for telling the receiving TCP stack to end a connection immediately. Note: Setting the RSTs may pose a security risk. Enter a number to limit how many packets get received before an ACK gets forced. If there is a large amount of data to acknowledge, an ACK gets forced. If the sender TCP implementation waits for an ACK before sending more data even though the window is open, setting the Ack Limit to 1 packet improves performance by forcing immediate acknowledgements. The Send Data selection governs when data may be sent into the network. The Standard implementation waits for an ACK before sending a packet less than the maximum length. Select Expedited to send data whenever the window allows it. Enter the maximum number of retransmissions of a packet that will be attempted before failing. XPort Pro User Guide 107