Lexmark 854e Menus and Messages Guide - Page 103

Attendance messages Message Meaning Action 52 Not enough free space There is not enough space in the in flash memory for flash memory to store the data resources currently being downloaded. Touch Continue to clear the message and continue the print job. Install flash memory with more storage capacity. Download the data. Touch Cancel Job to cancel the current job if needed. Touch Reset Active Bin to change to another linked bin. 52 Unformatted flash detected The MFP detects unformatted flash memory. Touch Continue to clear the message and continue printing. The MFP continues with normal operations except for flash operations. Reformat the flash to allow flash operations. If the error message reappears, the flash memory may be defective and require replacing. 54 Network [x] software error The MFP cannot establish communications with a specified installed network port. x indicates the number of the specified port. • Touch Continue to clear the message and continue printing. The job may not print correctly. • The MFP disables attempts to communicate through the network interface. No data may be sent or received. • Reset the MFP. • Program new firmware for the network interface. 54 Serial option [x] error The MFP detects a serial error, such as framing, parity, or overrun on the specified optional serial port. x is the number of the optional serial port. • Make sure the serial link is set up correctly, and the appropriate cable is in use. • Make sure the serial interface parameters (protocol, baud, parity, and data bits) are set correctly on the printer and host computer. • Touch Continue to clear the message and continue processing the print job; however the print job may not print correctly. • Turn the MFP off and then on to reset it. 54 Standard network software error The MFP firmware detects an installed network port, but cannot establish communication with it. • Touch Continue to clear the message and continue printing. The job may not print correctly. • The MFP disables attempts to communicate through the network interface. No data may be sent or received. • Reset the MFP. • Program new firmware for the network interface. 55 Unsupported option in slot [x] The MFP detects an unsupported option in the specified slot. x indicates the number of the specified slot. 1 Turn the MFP off. 2 Unplug the power cord from the wall outlet. 3 Remove the unsupported option. 4 Connect the power cord to a properly grounded outlet. 5 Turn the MFP on. 56 Parallel port [x] disabled A status request occurs over the parallel port, but the parallel port is disabled. Touch Continue. The MFP discards any data received on the parallel port. Touch Reset Active Bin to reset the active bin for a linked set of bins. 56 Serial port [x] disabled The MFP receives data across a serial port, but the port is disabled. Touch Continue. The MFP discards any data received on the serial port. Touch Reset Active Bin to change to another linked bin. 103