Lexmark C752 User Reference - Page 78
Held Jobs May Be, Empty Hole Punch
View all Lexmark C752 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Message Disk Recovery x/5 yyy% Empty Hole Punch Box Enabling Menus Engine Warming Enter PIN: =___ Fax Flushing Buffer Formatting Disk yyy% Formatting Flash Held Jobs May Be Lost What this message means What you can do The printer is attempting to recover the hard disk. Disk recovery takes place in five phases; the second line on the operator panel display shows the percent complete of the current phase. Wait for the message to clear. Warning: Do not turn the printer off while this message is displayed. The finisher hole punch waste box is Remove the finisher hole punch box, empty full. it, and then replace it. The printer is responding to a request to make the menus available to all users. Wait for the message to clear, and then press Menu to view the menus from the operator panel. See also: Enabling the menus The printer is warming the fuser assembly to prepare for printing. Wait for the message to clear. The printer is waiting for you to enter your four-digit personal identification number (PIN). Use the operator panel buttons to enter the PIN you identified in the driver when you sent the confidential job to the printer. See also: Holding a job in the printer The printer is processing an incoming Wait for the message to clear. fax. The printer is flushing corrupted print data and discarding the current print job. Wait for the message to clear. The printer is formatting the hard disk. When formatting takes longer than usual, the second line of the display shows the percent complete. Wait for the message to clear. Warning: Do not turn the printer off while this message is displayed. The printer is formatting the flash memory. Wait for the message to clear. Warning: Do not turn the printer off while this message is displayed. The printer memory is too full to continue processing print jobs. • Press Go to clear the message and continue printing. The printer frees memory by deleting the oldest held job and continues deleting held jobs until there is enough printer memory to process the job. • Press Stop to clear the message without deleting any held jobs. The current job may not print correctly. • Press Menu to open the Job Menu and cancel the current job. • To avoid this error in the future: - Delete fonts, macros, and other data stored in printer memory. - Install more printer memory. Note: The messages 37 Insufficient Memory and Held Jobs may be lost alternate on the display. See also: Holding a job in the printer; 37 Insufficient Memory 78