Lexmark C752 User Reference - Page 82
Resetting the Printer, Resetting Active Bin
View all Lexmark C752 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Message Programming Error P Queuing and Deleting Jobs Queuing Jobs Ready Ready Hex Reattach Remove Paper Resetting Active Bin Resetting Fuser Cnt Value Resetting the Printer What this message means What you can do An error occurred while the printer was programming code into memory. Correct the problem specified on the second line of the display: • P1050-A network file was used to program a non-network printer, or a nonnetwork file was used to program a network printer. • P109-An update file was used to program the printer, but the information did not fit within the space allocated in the Master Boot Record. • P112-An upddle.fls file was used to update the DLE code on a printer with a firmware card installed, but the DLE was not found on the firmware card. • P200-No firmware card is installed. The printer is deleting one or more held jobs and sending one or more jobs to print. Wait for the message to clear. See also: Printing and deleting held jobs The printer is sending one or more held jobs to print. Wait for the message to clear. See also: Holding a job in the printer The printer is ready to receive and process print jobs. Send a job to print. The printer is in Hex Trace mode and is ready to receive and process print jobs. • Send a job to print. All data sent to the printer is printed in hexadecimal and character representation. Control strings are printed, not executed. • Turn the printer off and then on to exit Hex Trace mode and return to Ready status. The specified device is either not fully connected to the printer or is experiencing a hardware failure. • Reestablish communication by removing the specified device and reattaching it to the printer. • Press Go to clear the message and continue printing without using the device. • In the case of a hardware failure, turn the printer off and back on. If the error recurs, turn the printer off, remove the specified device, and call for service. See also: Calling for service The specified output bin, or bins, is full. Remove the stack of paper from the specified bin(s) to clear the message. The printer is resetting to the active bin Wait for the message to clear. in a linked set of bins. The printer is resetting the counter that Wait for the message to clear. tracks wear on the fuser. The printer is resetting to the current default settings. Any active print jobs are canceled. Wait for the message to clear. See also: Changing menu settings 82